The ruler has an accuracy of ± 0.004 inch and supports several different measurement units. These measurement units can be changed at any time while using the ruler EXACTLENGTH PRO. Note that the displayed measurement will be simplified according to the requested unit of measurement. The unit's accuracy will not be affected.

 

 

Here is a list of supported measurement units formats:

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The input mask (eg: XX'XX X/X") will guide you when you enter a measurement. Through the mask, to move from one block to the next block without entering a value, simply use the dot (.) key. Positive and negative values can be changed alternately by pressing the "+/-".

 

Entries are validated by the software that will do the necessary simplifications appropriately. The limits for each block will be displayed if these limits are exceeded. No movement will be done if the measuring input is not validated.

Digital ruler with a motorized stop